|
Krud Kutter Concrete Clean & Etch
cleans
and prepares concrete, masonry and brick
for coating, staining or sealing.
|
|
Concrete Clean & Etch
is ideal for cleaning, degreasing, and acid etching concrete floors,
walls, basements, driveways, swimming pools, patios, and containment
areas prior to coating, staining or sealing. Safer and easier to
use than muriatic acid, it creates a porous surface, and provides the
even profile and uniform appearance preferred for clear coating
applications. It can also be used to remove efflorescence (alkali salts)
an to neutralize new concrete and new mortar joints on block, masonry,
and brick.
|
|
Water-based, biodegradable, odorless
& non-flammable.
|
|
Product Highlights |
 |
A safe
alternative to muriatic acid. Ideal for cleaning,
degreasing and acid etching concrete floors, walls, basements,
etc... prior to coating, staining or sealing. |
|
|
Concentrated formula cleans up to 1,000 sq ft per
gallon - or - 200 sq ft per quart. |
|
|
Water-based, biodegradable, odorless and non-flammable. |
|
|
Cleans and prepares concrete, masonry, and brick
for coating, staining or sealing. |
|
|
|
|
|
Frequently Asked Questions - answered!
|
|
Concrete Clean & Etch -
Directions for Use
|
|
PRODUCT GUIDELINES
Mix 1 quart (32 oz.) of concentrate with 3 quarts of water in a
plastic sprinkling can. This will yield sufficient premix to cover 200
sq. ft. Hot water will accelerate cleaning and etching.
Sweep the surface to remove loose debris, and scrape off excess
grease and oil.
Cleaning a 10 ft x 10 ft section at a time, dampen the surface with
a fine spray of water, and using the sprinkling can, apply the premix
evenly over the surface.
Scrub the premix into the surface with a stiff bristled broom until the
foaming stops. NOTE: If no foaming occurs, surface has been previously
sealed and this will prevent penetration of premix. Remove the sealer
and reapply KRUD KUTTER CONCRETE CLEAN & ETCH premix.
Triple rinse the surface with a water hose. Scrub while rinsing to
insure removal of all loosened material.
Allow the surface to dry thoroughly before applying stain or sealant.
After the surface has dried, check any glossy or oily areas by applying
a few drops of water. If water does not penetrate quickly, re-etch the
affected areas.
|
|
Caution:
Contains phosphoric acid. Eye
and skin irritant. In case of contact with eyes or skin, flush with
water for 15 minutes. If irritation persists, seek medical attention. If
swallowed, take large amounts of water. Do not induce vomiting. Get
medical attention.
KEEP OUT OF REACH OF CHILDREN. 24 HOUR MEDICAL EMERGENCY: CHEMTEL
(800) 255-3924
|
|
